As cold weather approaches, you will want to start thinking about winterizing the swimming pool. The main purpose in winterizing your swimming pool is to protect it from damage due to freezing water. Another reason to close the pool correctly is to keep it as clean as possible for the next season. Closing your swim pool properly can save you a lot of work when it comes time to open the swimming pool for the summer. Here are a few steps to follow that will make your pool as safe as possible for the winter and low maintenance to open when warm weather returns in the spring.
About 4-7 days prior to closing your pool for winter, bring your pool pH (7.6-7.8), pool alkalinity (80-100), and calcium hardness (150-250) in line. Shock the pool with a chlorine shock to bring the chlorine level up to 10-12ppm. Allow the pool chlorine to come down to its normal level, about 1.5-3.5ppm before adding any pool algaecides, pool winterizing chemicals, or your pool cover. If you are unsure of how to correctly balance the water, take a sample to your local pool retailer and they can test it and make recommendations.
Remove the skimmer baskets, heaters, slide, any wall fittings, vacuums, pool cleaners, ladders, handrails, or anything else that shouldn't be in the pool. Scoop out any debris on the top and bottom of the pool using a good leaf rake. At this point you may want to invest in a winter conditioner or a winterization swimming pool water treatment kit to keep your pool water chemistry on track. You can visit a local pool professional retailer to get all you need for your inground and above ground pool chemicals.
You'll want to do one final brush and vacuum to winterize your swimming pool. Once this is done, it's time to back-wash your filter.
You can either use your filter pump or a submersible pump to lower your pool water level. You'll need to lower the level about 3"-5" below the lowest plumbing line, normally the water return line. Be sure the water level is at least below the skimmer. You can remove the above ground pool skimmer.
Your pump, filter, heater, and chlorinator all have a drain plug. Either drain the water out of these or blow the line out with a shop vac. This will ensure all of the water has drained and none is left inside any plumbing lines. If you have a DE pool Filter or a cartridge filter, now would be a good time to take them out and clean the grids or cartridges and store them away for the winter. If the filter is small enough, you might be able to take it apart and store it for the winter. Keep the plugs out of these units. If you plug them back up and water happens to get into them, they might freeze over and crack your equipment. Place all the plugs in the skimmer basket during your pool winterization maintenance. By doing this, you'll know where they are when you need them next spring.
If you have a chemical feeder, now would be a good time to drain and empty it. By leaving chemicals in your chemical feeder during swimming pool winterization, you might damage your equipment. Remember to put the top back on the chemical feeder and be sure to wear safety goggles and gloves.
Now is the time to break out your above ground pool winter cover or inground pool winter cover to keep the debris out of the pool. Use a solid cover that keeps out all debris and sun. These solid covers should keep the pool clean and prevent algae growth. You should also use an air pillow. These air pillows hold the pool cover up like a tent so water and debris fall off instead of collecting on the top. They also help to take up any water expansion which could occur from freezing and possibly cause your above ground pool wall to split.
Spring is here and you have taken the necessary steps to get your pool area ready for endless hours in the backyard: You have cleaned up plant debris from the pool deck, patio, nearby planting beds. You have also taken the time to prune trees and hedges that have grown in recent months and might hang over your pool. You have also checked your supplies and purchased all new chemicals for this pool season and properly disposed of all chemicals from last season. Now, it’s time to remove the pool cover!
The last thing that you want to do is just pull the cover off, fold it up and place it in the shed. During the fall and winter months your pool cover accumulates water. Be sure to avoid mixing the water on the top of the cover with your pool water by using a pump or shop vacuum to remove the water from the top of the pool cover. After carefully removing the cover, take it to a driveway or other solid place on a slant or slope for easier drainage. Thoroughly sweep and hose off the cover, and use cleaner or treatment if it's recommended by the manufacturer of the cover. PoolStyle Clean-N-Store removes dirt, grease, oil, grime and deodorizes as well as protects the cover during storage – ensuring a longer life for your pool cover. You can pour the cleaner on and scrub it with a brush. There is no need to let the cover completely dry, however it is recommended that you buy a large plastic container to store your pool cover in. This way, it can remain wet and no insects will have access to it.
PLEASE NOTE: Pool dealers, builders, retailers and service providers listed on swimmingpool.com (referred to collectively as "dealers") are independent business persons and not agents of swimmingpool.com or any parents, subsidiaries or affiliates (referred to collectively as swimmingpool.com). swimmingpool.com does not accept any responsibility for any representations, statements or contracts made by any dealers listed on this website. Because all dealers are independent business persons, we recommend that you thoroughly research anyone you choose to do business with before making your final decision or entering into agreements.